The roll-up is one of the most commonly used display tools at events, in stores and at exhibitions. Often, though, it's not the structure that wears out, but the message that becomes outdated. In that case you don't need to buy a brand new roll-up – replacing the print is enough.
Roll-up print replacement is a cost-effective and eco-friendly solution, since your existing structure can be reused. Whether it's new graphics, a fresh offer, a current campaign or a refreshed brand identity, we swap the print quickly and easily, while the quality and stability you're used to stay the same.
We produce the prints on high-quality material, with vivid colors and sharp details, so your new roll-up looks every bit as good as a completely new product. It's an ideal solution for trade fairs, exhibitions, store decoration or seasonal promotions.
If you don't have finished artwork, we can help with the design too, so your display will be not only fresh, but effective as well.
Roll-up print replacement: a smart choice, lower costs, a new message.
Guide to replacing the print:
- Place the roll-up structure on a stable, flat surface, then pull out the support legs.
- Attach the bottom edge of the print straight to the double-sided adhesive in the cassette. It's always a good idea to reinforce this attachment with a piece of clear adhesive tape.
- Make sure the print is applied straight and centered, with no wrinkles or skew.
- Fasten the top edge of the print into the upper aluminum profile.
- After releasing the spring mechanism lock (by removing the locking pin on the side of the structure), slowly guide the print back into the cassette by hand, taking care that it doesn't snap back. IMPORTANT at this step: it's best to do this part with two people, one of you holding the print firmly taut while the other removes the locking pin. You may need to move the print a little to remove the pin, but it's very important to keep it constantly tensioned.
- You can place the pin in the holder at the bottom of the structure so that it's ready to use next time.
- Pull the roll-up out again, check that the print runs straight, then insert the support pole and set it up so it's ready to display.
